Wire bending machine
for the fixed retainer
BENDER II is an on-site retainer bending machine. Orthodontic and engineering specialists of YOAT Corp. have contributed to making the best way to reduce time and cost for both doctors and patients. Finally, BENDERⅡ has come out to the world.
It has never been before in the orthodontic wire bending field that a retainer is bent and
Just 10 minutes to make a new retainer!
Could you believe that it takes only 10 minutes to make a new retainer on-site?
It is very easy with simple three steps of BENDERⅡ
3D Scanning (3min/arch)
Wire Design (2min/arch)
Wire Bending (5min/arch)
Fixed Retainer Program FixR
FixR program is designated to support BENDERⅡ. Using FixR, anyone
can access easily to design a retainer. FixR can use 3D scanned files to check Maxillary, Mandible, and even Occlusion.
BEN-II-O (Round wire type)
BEN-II-R (Rectangular wire type)
0.0175 for BEN-II-O
0.016 x 0.016, 0.016 x 0.022 for BEN-II-R
400 x 245 x 285 mm